Waring JC4000 - Manual (Page 3)

DISASSEMBLY-ASSEMBLY INSTRUCTIONS
IMPORTANT: Citrus Juicer should be unplugged from
outlet when disassembling or assembling
parts.
DISASSEMBLING: (SEE FIG. 1)
1. After removing your Citrus Juicer from the box,
familiarize yourself with the parts by disassembling
the unit while referring to Fig. 1.
2. Pull off Splash Hood (4000 series only),
reamer and Strainer.
3. lift bowl off Motor Housing.
ASSEMBLING: (SEE FIG. 1)
1. Place bowl on Motor Housing with spout facing front
and resting in notch of motor housing.
2. Place Strainer inside of bowl.
3. Place reamer on Drive Shaft, and push down
firmly to seat.
4. Put Splash Hood on top of bowl (4000 series only).
CLEANING INSTRUCTIONS
Clean Juicer immediately after each use, and prior to initial use as follows:
1. UNPlUg POWEr COrD.
2. Separate all removable parts according to disassembly instructions.
3. rinse removable parts thoroughly under running water.
4. Wipe external surfaces of Motor Housing with a soft cloth or sponge, dampened
with water.
DO NOT IMMERSE MOTOR HOUSING IN WATER.
OPERATION
1. With power cord unplugged, assemble all parts per assembly instructions.
2. Plug power cord into appropriate electrical outlet.
3. Set the power switch to the ON (1) position, and allow a few seconds for motor to
reach full speed.
4. Place halved citrus fruit on rotating reamer, and push down firmly.
NOTE: your juicer is equipped with a protective device which will interrupt power and
stop the motor if the juicer becomes overloaded or overheated for any reason. Should
this occur, perform the following steps in the indicated sequence:
1. Set the power switch to the OFF (0) position.
2
Fig. 1
Splash Hood
reamer
Strainer
bowl
Motor Housing