Campbell Hausfeld SB524000 - Manual (Page 9)

9
SB524000
www.chpower.com
Stop using tool immediately if any of the following problems occur. Serious personal injury could result.
Any repairs or replacements must be done by a Qualified Service Person or Authorized Service Center.
Symptom Possible Cause(s) Corrective action
Air leaking at trigger valve O-Rings in trigger valve housing are
damaged Replace O-Rings . Check operation of Work
Contact Element (WCE)
Air leaking between housing
and nose 1 . Loose screws in housing 1 . Tighten screws
2 . Damaged O-Rings 2 . Replace O-Rings
3 . Damage to bumper 3 . Replace bumper
Air leaking between housing
and cap 1 . Loose screws 1 . Tighten screws
2 . Damaged gasket 2 . Replace gasket
Tool skips driving fastener 1 . Worn bumper 1 . Replace bumper
2 . Dirt in nose piece 2 . Clean drive channel
3 . Dirt or damage prevent fasteners or
pusher from moving freely in magazine
3 . Clean magazine
4 . Damaged pusher spring 4 . Replace spring
5 . Inadequate air flow to tool 5 . Check fitting, hose or compressor
6 . Worn O-Ring on piston or lack of lubri-
cation 6 . Replace and lubricate O-Rings
7 . Damaged O-Ring on trigger valve 7 . Replace O-Rings
8 . Air leaks 8 . Tighten screws and fittings
9 . Cap gasket leaking 9 . Replace gasket
Tool runs slow or has loss of
power 1 . Tool not lubricated sufficiently 1 . Lubricate tool
2 . Broken spring in cylinder cap 2 . Replace spring
3 . Exhaust port in cap is blocked 3 . Replace damaged internal parts
Fasteners are jammed in tool 1 . Guide on driver is worn 1 . Replace guide
2 . Fasteners are not correct size 2 . Use only recommended fasteners
3 . Fasteners are bent 3 . Replace with undamaged fasteners
4 . Magazine or nose screws are loose 4 . Tighten screws
5 . Driver is damaged 5 . Replace driver
Troubleshooting Chart