Casio AP-500 - Manual (Page 45)

Assembling the Stand
E-41
3. First secure the sides of the back panel with
the two I screws on the left and right.
• At location 4, slip the G clip onto to the I screw
before installing the screw.
• With back panel C resting on top of the feet 5 of side
panels A and B, press the back panel against
crosspiece D as you install the I screws.
4. Next, secure the bottom of the back panel C
with the six F screws.
5. Adjust the height adjustment screw 6 to
provide support so crosspiece D does not
bow downwards when the pedals are
pressed.
IMPORTANT!
• Pressing the pedals without adjusting height adjustment
screw 6 can result in damage to crosspiece D. Always
make sure you adjust height adjustment screw 6 before
operating the pedals.
6. Mound the piano onto the stand.
• Use the H butterfly bolts to secure the piano to the
stand.
• After ensuring that the screws on the bottom of the
piano hook into the cut outs in the stand brackets 7,
secure the piano with the H butterfly bolts.
• The butterfly bolts keep the piano from slipping off
the stand. Never use the piano without the butterfly
bolts installed.
5
I
I
4
G
C
F
A B (Back)
6
7
H
H
7
H
7
Back
Front
AP500_e.book 41 ページ ２００６年１０月１９日 木曜日 午後３時５４分