Winchester Repeating Arms 94 Pre 1992 (Historic Manual) - Manual (Page 16)

6. BEWARE OF BARREL OBSTRUCTIONS, for the safety of both your gun and yourself.
Mud, snow, and an infinite variety of other obstructions may inadvertently lodge in a
barrel bore. It takes only one small obstruction to cause dangerously increased pressures
that can ruin (swell or rupture) the finest rifle barrels.
BEFORE CHECKING FOR A BARREL OBSTRUCTION, BE CERTAIN NO LIVE ROUND IS IN
THE CHAMBER AND THAT THE MAGAZINE IS REMOVED AND FEED MECHANISMS ARE
COMPLETELY EMPTY. PLACE THE "SAFETY" IN THE "ON SAFE" POSITION.
Look through the barrel to be sure it is clear of any obstruction. If an obstruction is seen,
no matter how small it may be, clean the bore with a cleaning rod and patch as described
in "Cleaning and Maintenance Suggestions." Before the first firing, clean the bore
with a cleaning rod and patch, and wipe away any anti-rust compound in the
action/chamber areas.
7. ALWAYS UNLOAD YOUR RIFLE WHEN NOT IN USE. REFER TO "UNLOADING THE RIFLE"
FOR AN EXPLANATION OF HOW TO UNLOAD YOUR RIFLE PROPERLY.
As a safety precaution, it is preferable to disassemble your gun for storage. Store your
gun and ammunition separately -- well beyond the reach of children. Take all safeguards
to ensure your rifle does not become available to untrained, inexperienced or unwelcome
hands.
8. USE THE PROPER AMMUNITION.
The barrel and action of this rifle have been made with substantial safety margins over
the pressures developed by established American commercial loads. Nevertheless,
Browning assumes no liability for incidents which occur through the use of cartridges of
nonstandard dimensions which develop pressures in excess of commercially available
ammunition with standards established by the Sporting Arms and Ammunitions
Manufacturers' Institute (SAAMI).
BE ALERT TO THE SIGNS OF AMMUNITION MALFUNCTION.
If you detect an off sound or light recoil when a cartridge s fired, DO NOT LOAD
ANOTHER CARTRIDGE INTO THE CHAMBER. Open the action and remove all cartridges
from the magazine, chamber and action areas. With the action open, glance down the
barrel to make sure that an obstruction does not remain in the barrel. If there is an
obstruction, completely clear the barrel before loading and firing again. Failure to follow
these instructions can cause extensive damage to your gun and possible serious injury to
yourself and others.
MAKE SURE OF ADEQUATE VENTILATION IN THE AREA THAT YOU DISCHARGE A
FIREARM. WASH HANDS THOROUGHLY AFTER EXPOSURE TO AMMUNITION OR
CLEANING A FIREARM.
Lead exposure can be obtained from discharging firearms in poorly ventilated areas,
cleaning firearms or handling ammunition. Lead is a substance that has been known to
cause birth defects, reproductive harm and other serious injury.
9. DO NOT SNAP THE FIRING PIN ON AN EMPTY CHAMBER -- THE CHAMBER MAY NOT BE
EMPTY!
Treat every gun with the respect due a loaded gun, even though you are certain the gun is
unloaded.
10. KEEP FINGERS AWAY FROM THE TRIGGER WHILE UNLOADING, LOADING, UNTIL YOU
ARE READY TO SHOOT.