Vermont Casting 2479 - Manual (Page 26)

26
Dutchwest Non-Catalytic Convection Heater
30002291
um hose inserted into each passage. Care should be
taken not to damage the white fibrous material in this
rear chamber. (Fig. 34)
The Chimney Connector
TWO WEEKS:
• Inspect the chimney connector and chimney. Clean if
necessary.
TWO MONTHS:
• Inspect the chimney and chimney connector. Pay
particular attention to the horizontal runs of chimney
connector, and the elbows. Clean the system if nec-
essary.
ANNUAL SPRING CLEANING:
• Disassemble the chimney connector and take it
outdoors for inspection and cleaning. Replace weak
sections of connector.
• Inspect the chimney for signs of deterioration. Re-
pairs to a masonry chimney should be made by a
professional mason. Replace damaged sections of
prefabricated chimney. Your local Dutchwest dealer
or a chimney sweep can help determine when re-
placement is necessary.
• Thoroughly clean the chimney.
�����
��������������
����
Inspect and
Vacuum Both
Rear Corners
Ash Build-Up
ST876
Fig. 34 Inspect and clean out ash accumulation on either
side of the non-catalytic combustion system.