ClearOne comm ClearOne CHATAttach CHAT 150 User Manual
Page 20
Chapter 3: Using The Chat Application 17
CONNECTING THE CHAT 150 TO A VIDEO CONFERENCING DEVICE
Perform the following steps to connect your Chat 150 to a video conferencing device:
1.
Using the included RJ-45 cable, connect the VC Breakout Box to your Chat 150 (Figure 2.19).
2.
Using the included 6’ RCA cable, connect the Chat 150 VC Breakout Box to both your video conferencing
device and/or TV/monitor, as shown in Figure 2.20. The cable has two RCA connectors on one end, and
five on the other end, split into two groups with two and three connectors.
The end with two connectors goes to the VC Breakout Box; the blue connector connects to the audio in
port (identified by the icon), and the black connector goes to the audio out port (identified by the
icon).
On the other end of the cable, the group with the red and white connector plugs into the left and right
audio ports on your TV. This connection allows you to either use the speaker on your Chat 150 for audio
from the far end, or alternatively you can use the speakers on the TV. See Advanced Settings: Audio
Settings in Chapter 3: Using The Chat Application for details on using this option.
The group with three connectors goes to your video conferencing device. The red and white connectors
go to the audio out ports (right and left). However, if your video conferencing device does not have left
and right audio out, but only has a single channel, connect either the red or white connector to send a
mono audio signal to the Chat 150. The black connector goes to the audio in port.
(
(
)
)
(
(
)
)
FIGURE 2.19
Connecting Chat 150 to a Video Conferencing Device