LaMotte MINI BOD5 TEST KIT M-B User Manual
Page 2
To order individual reagents or test components, use the specified code numbers.
Carefully read the instructions for the Direct Reading Titrator before running this
titration. The Titrator is calibrated to read the test results directly in ppm (mg/L)
dissolved oxygen. Each minor division equals 0.2 ppm.
In ter fer ences:
Caustic alkalinity, mineral acid, free chlorine, and heavy metals are among the
factors that may influence test accuracy. BOD bottles must be extremely clean to
maintain consistent test results.
Wastewater Pre treat ment:
The pH of the sample should be in the range of 6.5 to 7.5. Adjust samples with
either 1N Sodium Hydroxide or 1N Sulfuric Acid to bring within this range.
Samples with free chlorine should be treated with 0.025N Sodium Sulfite solution.
None of the pretreatment reagents are supplied with this kit.
Di lu tion Wa ter Makeup:
Add 1 mL each of Phosphate Buffer, pH 7.2 (2843), Magnesium Sulfate, 1.10%
(3761), Ferric Chloride, 0.015% (3760) and Calcium Chloride,2.75% (3756)
solutions for each liter of distilled water. Store at temperature as close to 20°C as
possible. This water should not show a reduction in dissolved oxygen of more than
0.2mg/L on incubation for 5 days.
Follow Polyseed
TM
manufacturers direction when determining BOD
5
when seeding.
PRO CE DURE FOR BOD DE TER MI NA TION
1.
Determine the amount of sample(s) added to a 60 mL BOD bottle. Table I can
be used to estimate the amount of sample to add to the BOD bottle. Generally
raw municipal wastewater usually contains about 100 to 300 mg/L BOD
5
, so
0.6–1.2 mL of water sample is used. For primary and secondary treated
effluents, 9–15 mL samples should be used. Refer to Table I for other ranges.
Table I
Expected BOD
5
Range
Sample added to 60 mL
bottle(mL)
Minimum
(mg/L)
Maximum
(mg/L)
0.6
210
560
1.2
105
280
1.8
70
187
2.4
53
140
3.0
42
112
3.6
35
94
4.2
30
80
4.8
26
70
5.4
24
62
6.0
21
56
9.0
14
37
12.0
11
28
15.0
8
22
30.0
4
12