LaMotte OVERHEAD PROJECTION STAGES User Manual
Page 3
SOME TIPS TO FOL LOW DUR ING THE DEM ON STRA TION:
1.
Measure all test materials accurately.
2.
Add the materials in the order given in the instruction.
3.
Add materials to the correct test cell. If the materials are added to the
wrong test cell, the cell can be emptied using a pipet.
4.
Use a plastic spatula to stir and mix materials in the test cell. When
stirring granular materials do not press against the bottom of the cell.
This can cause small, distracting scratches on the cell.
5.
Wipe spatula clean before stirring a second sample.
6.
Do not stare directly down into the overhead projector. View the
demonstration from an angle on the side of the projector.
7.
Be careful not to spill test materials on the Transparency Guide or the
overhead projector.
CARE OF THE DEMONSTRATION STAGE
LaMotte Overhead Projection Demonstration Stages are ruggedly
constructed to provide many years of service. Attention to these simple
precautions will help prolong its usefulness.
1.
Rinse demonstration stage with warm water as soon as possible after
completing the demonstration.
2.
Dry with a tissue or soft cloth.
Avoid scratching the stage during rinsing and drying. Store stage in a safe
place, where it will not be scratched.