LaMotte DirectFlo DuoSoft 1028 - Manual (Page 11)

11
PROCEDURE E — continued
CLOSED
Turn on the sink
faucet. Adjust the
water fl ow until
the stream is about
¼” in diameter.
Turn the plug
clockwise
one complete
turn to lock it
into the
upright
position.
7. 8.
Close the
softener
valve.
9.
Place the softener in the sink
so that the stream of water
hits the top of the softener on the
side opposite the valve and fl ows
into the top well.
NOTE: Some
water will run
down the
outside of the
softener.
10.
Regeneration of media is now
complete. Close valve and cap.
NOTE: Before fi rst use, fi ll
bottom section of DuoSoft with
water to prevent vapor lock. Allow the softener
to fi ll with water.
When the softener
is full, open the
valve to rinse the
media with about
2 gallons of tap
water.
11. 12.