Corinex Global Corinex GameNet User Manual
Page 11
2.4.3 LED Definitions
2.4.3.1 VPI LED
VPI
Colour
Adapter Status
Meaning
Low Red
OFF (Standby)
Adapter is in Standby mode
Red
ON
If Powerline link, Estimated application
Throughput < Threshold 1
Orange
ON
If Powerline link, Threshold 1 <
Estimated application Throughput <
Threshold 2
Green
ON
If Powerline link, Estimated application
Throughput > Threshold 2
Rotating rapidly in red,
orange and green
ON
Adapter is on OBUS configuration Mode
The low and high throughput thresholds are default to be 6 Mbps and 12 Mbps
respectively, and can be redefined by users through the web interface.
2.4.3.2 ETH LED
When an Ethernet link is detected this LED will turn ON.
When there is an Ethernet link and there is Ethernet traffic on the link, the LED will
flash.
2. After five seconds, the VPI LED will switch ON again.
3. At this time, the adapter resets its configuration to the factory default
settings and automatically restarts.
The significant factory settings in the AV200 Wall Mount F are presented below:
• Default IP is 10.10.1.69
• Default configuration password is “paterna”
• Default factory reset password is “betera”
• Default network ID is the public network ID
• Default Encryption Key is none.
Installation
Corinex GameNet
9