Craftsman 486.24612 User Manual

Page 4

Advertising
background image

4

Call 1-866-576-8388 for missing parts or assembly help

DO NOT RETURN TO STORE

STEP 5:

(SEE FIGURE 6)

Spread ends of bumper enough to fit slots onto bolts

•

in rear mounting holes in tractor frame.
The bumper has three mounting holes. The rear

•

hole provides the most clearance while the forward
holes provide a neater appearance. Use a hole
that provides enough clearance for hood to stay in
raised position when opened. Insert a carriage bolt
and washer through tractor frame and into desired
mounting hole on each side of bumper and secure
with a whizlock nut.

IMPORTANT: Before fully tightening nuts, be sure
tractor hood will stay in raised position when opened.

CARRIAGE BOLT

AND WASHER

WHIZLOCK NUT

FIGURE 6

STEP 4:

(SEE FIGURE 5)

Insert a carriage bolt into the second mounting hole

•

from the front of the tractor frame and fully tighten a
whizlock nut onto the bolt. Repeat on other side of
tractor.

WHIZLOCK

NUT

CARRIAGE BOLT

AND WASHER

FIGURE 5

STEP 3:

(SEE FIGURE 4)

Place plug on a work bench or solid table and push

•

end of bumper down onto plug. Repeat for all plugs.

FIGURE 4

PLUG

SHORT STEP

BUMPER

PUSH DOWN

WITH EVEN
PRESSURE

WORK BENCH

OR SOLID TABLE

STEP 2:

(SEE FIGURE 3)

Remove tractor hood. (Refer to tractor manual.)

•

Remove the browning shield as shown.

•

FIGURE 3

REMOVE

BROWNING SHIELD

REMOVE

FRONT SCREWS

Advertising