This unit can power the following items, Operating instructions, Starting the engine – Chicago Electric 66619 User Manual

Page 9

Advertising
background image

Page 9

For technical questions, please call 1-800-444-3353.

SKU 66619

ThIS UNIT cAN PoWER ThE

FolloWING ITEMS

ITEM

RUNNING

WATTS

START-UP

WATTS

Ten 75 Watt Light Bulbs

750

1/4HP Compressor

600

900

1/6HP Motor

500

800

3/8” Drill

400

600

Mini Refrigerator

400

700

15 Amp Battery Charger

380

String Trimmer

350

500

Table/Box Fan

200

300

Radio

50

NoTE: Wattages listed above are estimates

for that type of equipment only. Check

nameplate wattages on all loads before

connecting to Generator.

oPERATING INSTRUcTIoNS

Read the ENTIRE IMPoRTANT

SAFETY INFoRMATIoN

section at the beginning of this

manual including all text under

subheadings therein before set up

or use of this product.

To PREvENT

SERIoUS INjURY:

operate only with proper spark

arrestor installed. operation of

this equipment may create

sparks that can start fires around

dry vegetation.

The operator should contact

local fire agencies for laws or

regulations relating to fire

prevention requirements.

Note: For additional information regarding the

parts listed in the following pages, refer

to the Assembly Diagram near the end of

this manual.

Starting the Engine

Inspect the Generator looking for

damaged, loose, and missing parts

before set up and starting. If any

problems are found, do not use the

unit until properly repaired.

checking and Filling The Fuel Tank:
cAUTIoN!
Your Warranty is VOID if the

Engine’s Fuel Tank (73) is not filled with

the proper mixture (50:1) of

unleaded

gasoline and 2-cycle oil before each

use. Before each use, check the fuel

level. Do not run the Engine with an

improper unleaded gasoline/2-cycle oil

mixture. Running the Engine with an

improper mixture WILL permanently

damage the Engine.
The Fuel Tank (73) holds approximately

1.

1 gallon of fuel.

FIGURE b

1 GAlloN

UNlEADED

GASolINE

2.5 FlUID oUNcES

2-cYclE oIl

APPRovED

coNTAINER

2. To obtain the proper gasoline and

2-cycle oil mixture, mix 2.5

fluid ounces

of 2-cycle oil with 1 gallon of unleaded

gasoline into an approved container.

Then slowly shake the container to

thoroughly mix the gasoline/2-cycle oil.

(See Figure b.)

REv 10b

Advertising