Caring for your labelmaker – Dymo LetraTag LT-100H User Manual
Page 17
18
Caring for Your Labelmaker
Your labelmaker is designed to give you long and trouble-free service,
while requiring very little maintenance. Clean your labelmaker from
time to time to keep it working properly. Clean the cutter blade each
time you replace the label cassette.
To clean the cutter blade
1. Remove the label cassette.
2. Place the tip of a ball-point pen
or pencil on the black post as
shown in Figure 6, and press the
post down.
3. While holding the post down,
press and hold the cutter lever to
expose the cutter blade.
4. Use a cotton ball and alcohol to clean both sides of the blade.
5. Release the cutter lever.
You can also follow this procedure if the cutter blade becomes
lodged in the forward position and will not move.
To clean the print head
♦
Clean the print head using the cleaning tool located inside the label
compartment lid.
Press in
and hold
Figure 6