Troubleshooting, Cleaning – Dymo 2000 User Manual

Page 5

Advertising

Note that the barcode symbol

1234

will appear in the

display whenever the cursor is positioned under
barcode characters.

• To edit a barcode, press

VERT

BARCODE

; the barcode

characters only will be displayed and the barcode
symbol

1234

will appear in the display.

• Press or

VERT

BARCODE

again to return to the label.

On a single line label, a bar code can be mixed with text
which is small, medium or large size:

A two-line label always has small size text when it is
mixed with a barcode.

Text entered before pressing followed by

VERT

BARCODE

, will result in text above the barcode:

Entering the text after pressing at the end of a

barcode will produce text below the barcode:

Text can be underlined, eg:

A box can be added around the complete label:

Troubleshooting

No display
• check machine is on
• replace discharged batteries
• check AC adaptor.
No printing or poor text
• replace discharged batteries
• check tape cassette installed correctly
• clean the print head
• replace the tape cassette.
Tape jammed
• lift out tape cassette carefully
• remove/release jammed tape
• DO NOT cut the ink ribbon – turn spool

B➎

tighten

• cut off excess label tape
• refit/replace the tape cassette.
Poor cutter performance
• clean the cutter blade regularly
Poor tab cuts
• replace tab cutter blade

F➊

– remove the cassette

then locate the cutter block and pull hard upwards to
remove.
WARNING – the blade is extremely sharp!

No response to print key
•

!!!!!!!!

in the display indicates a printer jam. Press

any key to return to normal display. Open the
cassette compartment and free the jam.

•

flashing in the display indicates

discharged batteries. Press any key to return to
normal display. Replace the batteries.

No success?
• Call the customer service telephone number in your

country – see the warranty booklet.
In the USA, call 800-645-6051
In Canada, call (905) 670-2222