Casablanca Fan Company Marrakesh 89UXXM - Manual (Page 8)

8
BLADE ASSEmBLY ON FAN INSTALLATION
Step 12. Rotate blade assembly until the other blade iron
hole aligns with the cut-out and again, install and tighten
screw by hand only. Repeat steps 11 and 12 until all 3 blade
assemblies are installed this way.
Perma•lock™ hardware
FAN PREPARATION
imporTanT safeTy informaTion!
BEFORE STARTINg THE INSTALLATION OF YOUR CEILINg FAN, INSTALL THE THREADED DOWNROD INTO THE mOTOR COUPLINg AND LOCK THE ASSEmBLY
mOTOR
COUPLINg
TAPERED
THREAD
mOTOR
WIRES
mOTOR COVER
ALLEN
SET SCREW
DOWNROD
& BALL
ASSEmBLY
6” DOWNROD
& BALL ASSEmBLY mOTOR COVER
Prepare for fan installation as follows:
Step 13. Place the motor cover on the downrod as shown.
Step 14. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is designed
to lock completely when correctly installed.
Step 15. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step 16. Securely tighten the set screw with the provided
allen wrench to ensure safe operation of your fan.
ALLEN SET SCREW
1 ⁄ 4 -20 x 1 ⁄ 4 ”
(PRE-INSTALLED)
3mm
ALLEN WRENCH
imporTanT safeTy informaTion!
BEFORE STARTINg THE INSTALLATION OF yOUR CEILINg FAN, INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLINg AND LOCK THE ASSEMBLy
CAUTION: Failure to fully lock in the down-
rod before securely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!