Monarch Instrument F2A1X User Manual
Page 3
more information. This product may be returnable to your distributor for
recycling - contact the distributor for details.
Monarch Instrument’s Limited Warranty applies. See
www.monarchinstrument.com for details.
Warranty Registration and Extended Warranty coverage available
online at www.monarchinstrument.com.
TABLE OF CONTENTS
TABLE OF CONTENTS
1.0
OVERVIEW .............................................................................
1
2.0
INSTALLATION .......................................................................
1
2.1
Power ............................................................................
2
2.2
Analog Out ....................................................................
2
2.2.1
Current Output Option ............................................. 3
2.2.2
Voltage Output Option ............................................. 3
2.3
Sensor Input .................................................................
3
3.0
USER PROGRAMMABLE HARDWARE SETTINGS .................
5
3.1
Sensor Power Voltage .................................................
6
3.2
Sensor Termination ......................................................
6
3.3
Input Coupling ...............................................................
6
4.0
USER PROGRAMMABLE SOFTWARE SETTINGS ..................
7
5.0
SPECIFICATIONS ....................................................................
8
6.0
OPTIONS AND ACCESSORIES / SENSORS ...........................
9
7.0
APPENDIX A - Serial Programming Commands ................
10
@CH_A/LOEND = 12 (or 1_SEC, HALF) Sets low end time. This allows a
min reading of 5 RPM, 60 RPM, or 120
RPM.
@CH_A/GATE
Show Gate Speed. (Default is 12)
@CH_A/GATE = STD (1/100 Second) or FAST (1/1000 second). Sets Gate
Speed (Default is 1/100)
@DECPT
Shows the number of decimal places
displayed
@DECPT = NONE, 1, 2, or 3
Sets the maximum number of decimal
places.
@DAC1/ FSCAL
Shows Analog Out Full Scale
@DAC1/FSCAL = xxx.xx
Sets the Reading value that the Analog
output will output Full Scale (5V or
20mA). Depends on TYPE.
@DAC1/0SCAL
Shows Analog Out Zero Scale
@DAC1/0SCAL = xxx.xx
Sets the Reading value that the Analog
output will output Zero Scale (0V or
4mA). Depends on TYPE. (Default is
0.00)
@DISPR
Shows Display Update Rate
@DISPR = HALF or 1_SEC or 1.5_S. This sets the maximum display
update rate to one half a second, 1 second
or 1 ½ seconds between updates.
@SERNO
Shows unit Serial Number
11