Wheatheart In-Bin Super Sweep - Manual (Page 7)

W HEATHEART - I N -B IN S UPER S WEEP 1. A SSEMBLY
A LL M ODELS 1.3. A SSEMBLY
IM5-R1 7
1.3. ASSEMBLY
1. Mount tower over opening in floor and in the center of the bin.
2. Remove hairpin and slide pivot assembly down pivot shaft until it rests on the
collar. Mount motor to pivot assembly with 3/8” bolts.
3. Attach special motor coupler to hydraulic motor and then a straight bin sweep
section pinning in place. Add on extra straight sections as needed with the
last long section having the walking shoe. Add the 15” section to the end,
space permitting.
4. Make sure all sections are fully interlocked. The pins on the backboards fit
into the hole of the next section and the flighting sections line up to form one
continuous auger when twisted into place. (The welded finger on the end of
one section of flighting wraps around the spoke on the stationary wheel of the
next section.) (See Figure 1.4 and 1.5.)
Figure 1.4 In-Bin Tower and Pivot Assembly