Clarion DSH920S - Manual (Page 7)

DSH920S
7
English
Selecting Sirius Radio modes
Press the [SAT] button or the [FNC] (FUNC) but-
ton to select the Sirius mode.
The Sirius indication lights entering the mode
that was engaged when the unit was turned off
last time.
Notes:
• The [SAT] button selects the Sirius mode directly.
Some source unit does not have a [SAT] button. If
not, press the [FNC] (FUNC) button.
• The [FNC] (FUNC) button selects the external de-
vices connected to the source unit in order, for ex-
ample: Radio mode
➜ DAB mode ➜ Sirius mode
➜ CD mode ➜ CD changer mode ➜ …
Selecting a band
Press the [BND] button to select a band.
Each press of the button changes the display as
shown below.
SR1 ➜ SR2 ➜ SR3 ➜ SR1 …
∗
The currently received band is displayed in the func-
tion mode indication.
∗
Models without a function mode indication display
the band name and channel number in the Opera-
tion status indication.
● Information displayed during reception
The following information is displayed in the Op-
eration status indication when Sirius Radio can-
not be received normally.
• UPDATING : when the receiver is turned on
the first time or after a reset
• ACQUIRING : when a channel is being tuned
in (no signal is yet received)
(“LINKING” is shown on an 8-
digit display)
• INVALID CH : a channel without a broadcast
has been selected
(“INVLD CH” is shown on an 8-
digit display)
• NO SIGN-UP : a channel not covered by your
contract
• ANTENNA : no antenna is connected or the
antenna is defective)
Switching the display
1. Press the [DISP] (D) button to select the de-
sired display.
The main display or the clock display ap-
pears each time you press the [DISP] (D)
button.
4. SIRIUS OPERATION
2. In the main display, press and hold the
[DISP] (D) button for 1 second or longer to
cycle between the following display modes:
Channel name
➜ title ➜ artist name ➜ cat-
egory name ➜ text ➜ channel name ➜ …
Notes:
• The Operation status indication of the source unit
displays the abbreviated channel name for 2 sec-
onds when a station is selected before returning
to the previous display mode.
• Scrolling starts when the channel name or other
text has been displayed for 2 seconds. When
scrolling finishes, the first text display appears.
To start scrolling again, press the [ADJ] button.
• The [ADJ] button is described in the source unit
instruction manual either as the [T] (TITLE) button
or [A-M] button. This refers to the function of the
button labeled “ADJ” on the source unit panel.
Channel selection
Channels are selected with the following but-
tons.
• The [ a ] or [ d ] button
• A [DIRECT] button
• The [SCN] (SC) button
• The [CAT] (RDM) button
∗
For details, see the following operation descriptions.
Notes:
∗
The audio output is muted and other button op-
erations are not accepted during channel selec-
tion.
Tuning mode (T-MODE)
There are two channel selection modes: seek
mode and manual mode.
● Seek tuning
Only channels that can be received are selected
while channels without broadcasts and channels
not covered by the contract are automatically
skipped.
1. Press the [ a ] or [ d ] button.
The receiver seeks the next available chan-
nel below or above the current channel.
2. Press and hold the [ a ] or [ d ] button.
or etc.