Cub Cadet 5252 - Manual (Page 32)

32
Electrical Circuit Relays
Several relays, which operate electrical functions of
the tractor, are located inside the lower dash panel.
If one of the circuits is not functioning properly,
have your dealer electrically check the relay. See
Figure 39.
• Start Relay — Functions in the start circuit.
• PTO Relay — Operates in conjunction with
both the Reverse Relay and Reverse Override
Relay to engage the PTO.
• Reverse Relay — Functions with the PTO
Relay and Reverse Switch in the "No Cut in
Reverse" circuit.
• Reverse Override Relay — Functions with the
Reverse Override Switch and PTO Relay to
maintain PTO engagement when driving in
reverse.
• Cruise Control Relay — This relay is installed
at the factory for use with the optional Cruise
Control Kit. The relay functions in the cruise
control circuit, when the kit is installed.
Figure 39
Hazard Light Flasher Relay
The flasher relay, which controls the on/off flashing
of the hazard lights, is located inside the lower dash
panel.
Replace the relay as follows:
• Pull the wire harness from the right side of the
dash opening and remove the electrical tape
from the flasher relay. Refer to Figure 40.
Figure 40
• Note the position of the two harness leads, then
disconnect the leads and replace the faulty
relay with a new relay. Secure the relay to the
wire harness with electrical tape.
• Position the wire harness in the dash panel and
reinstall the dash panel insert.
CHECKING TRANSMISSION/HYDRAULIC
SYSTEM OIL LEVEL
Check the hydro transmission/hydraulic system oil
level before each use. NOTE: Check the oil level
only while the engine is stopped and the tractor is
standing on a level surface.
The oil level sight glass is located in the rear of the
transmission housing, just to the right of the rear
PTO shaft. Refer to Figure 41.
The oil level is okay if oil can be seen through the
sight glass. If the level is below the sight glass, oil
must be added to the transmission as follows:
• Locate the oil fill plug on the upper right of the
rear of the transmission housing. See Figure 41.
Figure 41
• Clean the area around the oil fill plug to prevent
debris from entering the transmission housing.
Right Side
Left Side
START
RELAY
PTO
RELAY
CRUISE
CONTROL
REVERSE
OVERRIDE
RELAY
REVERSE
RELAY
RELAY
(OPTIONAL)
FLASHER
RELAY
TAPE
HARNESS
LEADS
WIRE
HARNESS
OIL FILL PLUG
OIL LEVEL
SIGHT
HOLE