Amico Majestic Series Single Tier Surface Mounted Headwall - Manual (Page 6)

6 Amico Architectural
Installation
7. Hang the headwall unit on the wall, over the mounting bracket, and center the unit with refer-
ence to bed center line. Verify rough-in locations in wall and align with rough-in provisions on
headwall.
8. Make all necessary medical gas and electrical connections at rough-in locations.
9. Secure headwall to the wall through lower section using hardware compliant to local building
codes (provided by others). Lower bracket is to be drilled on-site according to stud location.
Replace lower headwall cover when done.
10. Replace any fascia panels and covers removed in step 5 and 6.
End plate and cover removed in this
view to show detail. Do not remove!
Note
lower mounting locations