Roll stand installation (roll stand base assembly) – Amico Monitor Roll Stands User Manual
Page 7
www.amico.com
6
Figure 2
Casters
Roll Stand Post
Long Bolt
Lock Washer
Large Washer
Roll Stand Bushing
Casters
Figure 1
Long Bolt
Lock Washer
Large Washer (Silver)
Hardware Kit 1
NOTE:
Figure 2 is an exploded view of the Roll Stand base assembly.
NOTE:
DO NOT use a hammer on the casters or the Roll Stand post.
1. Hardware Kit 1 has the necessary hardware for the instructions in this section.
(Figure 1)
2. Push locking casters into the base by hand until it clicks in place. Repeat for all 5 casters.
3. Insert the end of the Roll Stand post with the bushing into the Roll Stand base. Secure the post to the Roll Stand
by inserting the long bolt, through the lock washer, and then the large washer through the base, into the Roll
Stand post and tighten with ½" wrench. Ensure all connections are secured.
(Figure 2)
Roll Stand Installation (Roll Stand Base Assembly)