4 medical air systems glossary definitions – Amico CSA Triplex SCD Modular Stack Mount User Manual

Page 9

Advertising
background image

www.amico.com

6.4 Medical Air Systems Glossary

Definitions

ICFM

•

Conditions at the inlet of the compressor prior to any restrictions or

temperature changes. (i.e., inlet filters, inter-coolers, discharge manifolds

etc).

Displacement

•

Theoretical physical volume of the air in the compressor chamber based

upon 100% pumping efficiency, with no allowances made for heat,

friction, clearances, or other losses in the compression cycle.

Peak Calculated

•

The maximum estimated demand a medical facility will require of a

Load (PCL)

medical air system.

•

Calculated at SCFM at 100 psig.

Oil-Free Compressor •

Compressor with oil within the compressor but absent from the

compression chamber by means of seals and visible vented distance

piece, and a dry compression chamber.

Simultaneous Demand •

Operating reference to a condition where all compressors (Lead and Lag

compressors) run simultaneously to satisfy demand in excess of lead

compressor(s)

capability.

Dew Point

•

Temperature and pressure at which medical air will condense water

vapor into liquid water within the medical air pipeline system.

Continuous Duty •

Air compressors which can operate continuously (24 hours per day) if

Rated

necessary but normally only operate on demand.

LPM

•

Abbreviation for Liters per minute; a measure of the flow rate of a gas.

Quadruplex System

•

Medical air system with four compressors (4), each sized for 50% PCL.

ACFM

•

Actual Cubic Feet per Minute is an expression of actual air volume,

generally corrected for and reference to a particular pressure.

Continuous Duty

•

Operational reference to compressors operating 24 hours a day,

continuously.

Duplex System

•

Systems comprised of two (2) compressors, each rated for 100% Peak

Calculated

Load

(PCL).

Desiccant Dryer

•

Consists of two towers, whereby the desiccant bed in one tower dries the

air stream while a purge of dry air regenerates the desiccant bed in the

other

tower.

NTP

•

“Normal Temperature and Pressure”, generally accepted as 20˚C (70˚F),

14.969 psi/29.92” Hg barometric pressure, and 36% relative humidity.

Dew Point/CO Monitor •

Monitors dew point and carbon monoxide levels in medical air.

Oil-Less Compressor •

Compressor with no oil contained within the compressor.

SCFM

•

Standard Cubic Feet Per Minute is an expression of air at NTP.

Triplex Systems

•

Medical air system with three compressors (3), each sized for 100% PCL.

7

Advertising