Retro-fit instructions – Amico Puritan Bennett Retro-Fit Gas Control Panel User Manual

Page 3

Advertising
background image

www.amico.com

3

C h e m e t r o n G a s C o n t r o l P a n e l R e t r o - F i t

P a g e : 2

Puritan-Bennett Control Panel.
Remove screws from panel.

Mount the filler frame to the wall

using the appropriate hardware for

the type of wall you are mounting to.

There are 6 holes provided for

mounting the frame.
Note: The frame can not be mounted

on the wall centered on the existing

back box. The retrofit is shipped with

the filler frame attached to the control

panel. Before you take these apart,

push the assembly into the existing

back box and position it into place

and mark off the corners of the frame

on the wall. These lines will be your

reference for mounting the frame to

the wall.

Remove all internal components.

P a g e : 3

C h e m e t r o n G a s C o n t r o l P a n e l R e t r o - F i t

Install the male elbows into the

threaded connections in the back

box. Connect the input tube into the

appropriate fitting in the back box as

shown.
Push the whole assembly gently into

the back box and secure the panel to

the filler frame using the #8 stainless

steel machine screws provided with

the kit. Please note the position of the

pigtails.

Mount the filler frame to the wall using the appropriate

hardware. There are 6 holes provided for mounting the

frame.

NOTE: The frame can not be mounted on the wall centered

on the existing back box. The retrofit is shipped with the

filler frame attached to the control panel. Before you take

these apart, push the assembly into the existing back box

and position it into place and mark off the corners of the

frame on the wall. These lines will be your reference for

mounting the frame to the wall.

Install the male elbows into the threaded connections in

the back box. Connect the input tube into the appropriate

fitting in the box as shown.

Push the whole assembly gently into the back box and

secure the panel to the filler frame using the #8 stainless

steel machine screws provided with the kit. Please note the

position of the pigtails.

Retro-Fit Instructions

Advertising