Chief Manufacturing Universal Slat Wall Multi Arm Mount KSY220 - Manual (Page 7)

Installation Instructions KSY220
7
Figure 6
6. Repeat display installation procedures for second display.
7. Proceed to "CABLE MANAGEMENT."
Recessed Mount Display Installation
1. Ensure Centris bracket is able to swivel and tilt easily, yet
still be tight enough to hold display in desired position.
Adjust as required before proceeding. See
"ADJUSTMENT" for detail.
2. Carefully place display face down on a clean and dry
surface.
3. Determine depth of recessed mounting holes relative to
back surface of display.
4. Select proper length spacer and screw from table below:
IMPORTANT ! : All spacers used should be the same length.
If the recess depths result in multiple spacer lengths, then
select the longer spacer.
5. Place the four spacers (Q1 or Q2) over each mounting hole
on the back of display. (See Figure 7)
6. Orient mount so that mounting holes in the Centris cup are
aligned with the holes in the spacers (Q1 or Q2); rotate the
Centris cup as required (See Figure 7).
CAUTION: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
7. Using Phillips screwdriver, install four screws (Q4 or Q5)
through the mounting holes in Centris cup, through the
spacers (Q1 or Q2), into display (See Figure 7).
8. Tighten all four screws. Do not overtighten!
9. Return to mount installation section to continue.
10. Repeat display installation procedure for second display.
Figure 7
Cable Management
1. Attach all cables to display.
2. Open the cable management bracket by sliding it towards
the edge of the arm (See Figure 8).
NOTE: If necessary, cable management bracket attach screws
may be loosened using hex key.
Figure 8
CAUTION: Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched
when bracket is closed.
3. Carefully insert cables into bracket (See Figure 9).
IF recess DEPTH is: THEN use spacer: AND screw:
3/8" or less Q1 (3/8" long) Q4 (M4 x 20mm)
More than 3/8" up to
and including 3/4" Q2 (3/4" long) Q5 (M4 x 30mm)
(Q3) x 2
Centris Cup
4
(Q4 or Q5)
(4 places)
(Q1 or Q2)
(4 places)
Centris Cup
7
5
OPEN Position CLOSED Position
View from Bottom
Attach
Screws