B&G H1000 NMEA Interface - Manual (Page 7)

selectable NMEA
The Selectable NMEA feature allows control over which sentences are received and transmitted by the h1000
Universal Interface. This gives flexibility when interfacing to other manufacturers’ products such as radars and
chart-plotters. Selectable NMEA allows you to filter out unwanted NMEA messages and prevents duplicated data
on the system.
3rd Party
Pilot
3rd Party
GPS
3rd Party R adar
Plo tter/GPS
h1000-U NI
h1000-U NI
h1000
System
Instrument
N MEA
Sentences
GPS N MEA
Sentences
GPS + Instrument
N MEA Sentences
Configuring Selectable NMEA
Identify the Universal Interface Box you wish to configure, this is identified by the first three digits of the serial
number found on the printed label located inside the lid of the interface box. Select the chosen box from the list
displayed, select either NMEA In or NMEA Out. The options available are detailed as follows:
Selecting NMEA Input sentences – ‘Current Input’ - Press ENTER to select, press ENTER again and scroll
through the listed sentences, press ENTER to view the options. Press ENTER and scroll to either On or Off,
press ENTER to make your selection. Scroll to OK to return to the listed sentences. Repeat the operation until
you have made all your selections.
Selecting NMEA Output sentences – ‘Current Output’ - Follow the same procedure as detailed above.
Renaming the interface box – ‘Name’ - Press ENTER to re-name the interface box (if required), use the
UP/DOWN arrow keys to select the number or letter required (maximum 10 characters), once you have
completed your name change scroll to, and highlight OK, press ENTER to return to the Remote units screen.