Bio-Rad Peelable Foil Heat Seal - Manual (Page 6)

n
EN 61010-1:2011 Safety requirements for electrical equipment for measurement, control, and
laboratory use — Part 1: General requirements
n
EN 61010-2-010:2003 Safety requirements for electrical equipment for measurement, control, and
laboratory use — Part 2-010: Particular requirements for laboratory equipment for the heating of material
n
UL 61010-1:2004(R2008) Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use — Part 1: General Requirements
n
UL 61010A-2-010:2002 Standard for Electrical Equipment for Laboratory Use — Part 2: Particular
Requirements for Laboratory Equipment for the Heating of Material
Electromagnetic Compatibility (EMC)
This instrument has been tested and found to be in compliance with all applicable requirements of the
following electromagnetic compatibility standards:
n
IEC 61326-1:2005 Electrical equipment for measurement, control, and laboratory use — EMC
Requirements, Class A
n
EN 61326-1:2006 Electrical equipment for measurement, control, and laboratory use — EMC
Requirements, Class A
n
FCC Part 15, Subpart B, Sections 15.107 and 15.109 as a Class A digital device
EMC Notices
n
Warning: Changes or modifications to this unit not expressly approved by Bio-Rad Laboratories
could void the user’s authority to operate the equipment.
n
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radiofrequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own expense.
n
Note regarding FCC EMC compliance: Although this instrument has been tested and found to
comply with Part 15, Subpart B of the FCC Rules for a Class A digital device, please note that this
compliance is voluntary, as the instrument qualifies as an “exempted device” under 47 CFR 15.103(c),
in regard to the cited FCC regulations in effect at the time of manufacture.
n
Note regarding Canadian EMC compliance: Le present appareil numerique n’emet pas de bruits
radioelectrique depassant les limites applicables aux appareils numeriques de class A prescrites dans le
reglement sur le brouillage radioelectrique edicte par le Ministère des Communications du Canada.
Warranty
The PX1 PCR plate sealer and associated accessories are covered by a standard Bio-Rad warranty.
Contact your local Bio-Rad Laboratories office for details of the warranty.
iv