Bio-Rad GelAir Drying System - Manual (Page 14)

Appendix A
GelAir Drying System Specifications
Specifications
Input rating
Catalog number 165-1777 115 VAC. 60 Hz, 6.0 A
Catalog number 165-1778 230 VAC, 50 Hz, 3.0 A
Installation category II
(overvoltage category)
Environmental conditions Indoor use only
Temperature 5 °C to 40 °C
Operating humidity 9-95%, non-condensing
Altitude Up to 2,000 M
Input power cable 3-wire; grounded
Timer control 0 to 3 hr, fully adjustable
Function modes Off, Fan Only, Fan plus Heat
Dryer capacity 4 shelves, 4 drying frames
Drying frame area 20 cm x 20 cm
Drying frame capacity 1 large format gel (20 x 16 cm) or 4 small format gels
(7 x 8 cm)
Dryer dimensions 27 x 43 x 30 cm (H x D x W)
Dryer weight 8 kg
Chemical resistance All of the GelAir components are resistant to corrosion
due to common electrophoresis chemicals
Appendix B
Warranty Information
The GelAir Drying System is warranted for 1 year against defects in materials and work-
manship. If any defects should occur during this warranty period, Bio-Rad Laboratories will
replace the defective parts without charge. However, the following defects are specifically
excluded:
1. Defects caused by improper operation.
2. Repair or modification done by anyone other than Bio-Rad Laboratories or their autho-
rized agent.
3. Deliberate or accidental misuse.
4. Damage caused by disaster.
For inquiry or request for repair service contact your local Bio-Rad office, listed on the
back cover.
10