Cooper Instruments & Systems Model 5i Advanced Force/Torque Indicator - Manual (Page 30)

Model 5i Digital Force / Torque Indicator User’s Guide
29
This section is used to configure the initial settings upon powering on the indicator. The initial units of
measurement and the primary reading measurement mode may be configured. To access these settings,
select Initial Settings from the menu. The screen will appear as follows:
The default unit of measure depends on the sensor series. The default mode is Real Time, regardless of
sensor.
12.6 Information / Welcome Screen
The following screen is displayed at power up and can be accessed at any time by selecting Information
from the menu:
Digital Indicator
Model M5i
Ind. SN: 1234567
Sensor: MR51-50
Sensor SN: 9876543
Version: 1.0
INITIAL SETTINGS
Units
LBF
Mode
Real Time