CTEK Z4200U SkyRouter - Manual (Page 5)

26 October 2012
1
Preface
Welcome to the Ctek Z Series Cellular Router User’s Guide. This manual covers the Z4200 EVDO and the Z4400
UMTS/HSPA router. The User’s Guide will explain the basic operation of the router and take you through the necessary
settings to get your wireless application online. Additional information and applicable technical notices can be found at
www.ctekproducts.com .
Note that all administrative functions and screens on the two models are identical with the exception of the Wireless
Status and Wireless Interface screens, and the Z4200's Activation screen which is replaced on the Z4400 by a SIM Tools
menu item.
1 Introduction
Wireless routers provide application and network designers with a bridge between the world of IT infrastructure and the
evolving wireless M2M networks. With the Z Series the wireless transport is fully integrated into the product’s routing
fabric meaning that you can approach the setup and operation of this product much as with any other IP addressable
device. Wireless considerations are reduced to the absolute minimum necessary to register and make connections on a
network.
A number of optional controllers are available for use with the models covered in this manual including a micro amp
standby power controller, an analog/digital I/O controller, and a relay power controller. The operation of these devices is
covered in their specific user manual and in applicable TechNotes.
1.1 Theory Of Operation
The Z Series router is a complete IP router that routes traffic over LAN Ethernet (10/100baseT) connections. The wireless
features of the router simply extend the IP routing capabilities to include routing and network address translation (NAT)
over cellular wireless networks. As with most routers Ctek’s Z Series can be viewed as having a Local Area Network
(LAN) side and a Wide Area Network (WAN) side. Traffic originating at the router’s Ethernet or Serial port is considered
LAN traffic. The Wide Area Network connection is over the wireless network’s 1XRTT transport.
1.2 Features
This manual covers Ctek Z Series and contains the following feature and functions.
1) Ethernet
a. Static Addressing
b. Dynamic (DHCP) Server
c. Configurable
DNS address
d. Configurable Gateway, Sub net mask, and Broadcast address
e. Port Forwarding
f. Service management
2) Wireless Interface
a. Enable/Disable WAN Interface
b. Enable/Disable inbound IP requests
c. DDNS Interoperability with Ctek's enhanced UDP interface
d. DDNS Interoperability with BIND or MS Server
e. Administration web server port address selection
f.
Enhanced network activation (Z4200)
g. Home Network Selection