CTEK Automation Control Application APN007 User Manual
Page 16
Application Note – Automation Control Application
APN007 25 July, 2014
11
Configure Outputs
A representative portion of the Configure Outputs navigation screen is shown below. This is a
selection screen. Use the Type pull-down and Edit button to select a specific Output for edit. To
completely disable an output select Disabled in the pull-down and then press the associated edit
button.
The default display shows the current status of outputs across all modules. Output pins are
assigned numbers and displayed sequentially starting with the first module installed
Note:
Output values are managed in one of four ways:
1.
From the individual output's edit screen (output state field or current value + Submit)
2.
By an On/Off button on the Control Panel
3.
By the Shutoff Timer value on an output
4.
Under program control by functions that are triggered by the threshold values of inputs
NOTE:
Each of these methods of changing an output state operates independent of the other, meaning
that one method might change the state of an output pin and another method could immediately
change it back. In other words an output manually turned on could be switched off by a threshold
when it is reached.
Figure 11 - Output Configuration Screen