Yealink SIP-T46G - Manual (Page 26)

User Guide for the SIP-T46G IP Phone
16
To configure a static IPv4 address via phone user interface:
1. Press Menu->Advanced (password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select the Static IP from the Type field.
3. Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS
and Secondary DNS fields respectively.
4. Press the Save soft key to accept the change or the Back soft key to cancel.
To configure a static IPv6 address via phone user interface:
1. Press Menu->Advanced (password: admin) ->Network->WAN Port->IPv6.
2. Press or , or the Switch soft key to select the Static IP from the Type field.
3. Enter the desired values in the IP Address, IPv6 IP Prefix, Gateway, Primary DNS and
Secondary DNS fields respectively.
4. Press the Save soft key to accept the change or the Back soft key to cancel.
If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a PPP negotiation
to obtain the IP address. Contact your system administrator for the PPPoE user name
and password.
To configure PPPoE via phone user interface:
1. Press Menu->Advanced (password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select the PPPoE from the Type field.