BMW 2006 bmw 325i - Manual (Page 174)

174 n Towing the vehicle
Tow fitting
The screw-in tow fitting is stored in the
onboard tool kit; be sure that it remains
in the vehicle at all times. This fitting is
designed for installation in the tow
sockets located at the front and rear of
the vehicle. It is intended for towing on
paved road surfaces only. This fitting
should not be used to pull a vehicle out
of deep snow, mud, sand, etc.
Always comply with all applicable
towing laws and regulations.
Access to tow sockets
Front:
Use a screwdriver in the upper section
of the recess to press the cover out.
460de063
Rear:
Use a screwdriver in the upper section
of the recess to press the cover out.
Screw the tow fitting in completely
and tightly. If you do not, the
threads could be damaged.
Do not tow the vehicle by any compo-
nents of the running gear, or lash them
down in any way. If you do so, the
components could be damaged,
leading to possible accidents.
<
460de064
Towing with a commercial tow
truck
> Do not tow with sling-type equip-
ment.
> Use a wheel lift or flat bed equip-
ment.
> Please comply with applicable towing
laws.
Never allow passengers to ride in
a towed vehicle for any reason.
Never attach tie-down hooks, chains,
straps, or tow hooks to tie rods, control
arms, or any other part of the vehicle
suspension, as severe damage to these
components will occur, leading to
possible accidents.
c
380us1
24
Online Edition for Part No. 01 41 0 155 476 - © 09/00 BMW AG