Universal garage door opener – FORD f150 User Manual

Page 126

Advertising
background image

To program another rolling code device,
repeat Steps 1 through 6, substituting a
different function button in Step 5.

Fixed Code Programming

Note: It may be helpful to have another
person assist you in programming the
transmitter.

To program units with fixed code DIP
switches, you will need the garage door
hand-held transmitter, paper and a pen or
pencil.

1. Switch the ignition on.

2. Open the battery cover and note all the
switch settings from left to right.

E164778

When the switch is in the up, on, or +
position, mark down “left button”.

When the switch is in the middle,
neutral, or 0 position, mark down
“middle button”.

When the switch is in the down, off, or
– position, mark down “right button”.

3. Press all three function buttons
simultaneously for a few seconds and then
release. The LED lamps will flash slowly.

E164776

Note: You must complete the following
step within 2.5 minutes.

4. Enter the corresponding DIP switch
settings from left to right into the system
by pressing and releasing the buttons
corresponding to the settings you noted.

5. Simultaneously press and release all
three function buttons. The LED lamps will
illuminate.

E164776

6. Press and hold the function button you
would like to use to control the garage
door.

Note: You may need to hold the button
from 5–55 seconds before observing
movement of the garage door.

7. When the garage door moves, release
the button within one second. After you
release the button, the LED lamp will flash
slowly.

8. The LED lamp will begin to flash rapidly
until programming is complete. If your
garage door does not operate, repeat the
previous steps. Otherwise, call the toll-free
help line at 1-866-572-2728.

The LED lamp above the selected button
will illuminate to confirm that the system
is responding to the button command.

Erasing the Function Button Codes

Note: You cannot erase individual buttons.

1. Press and hold the outer two function
buttons simultaneously for approximately
20 seconds until the LED lamps above the
buttons flash rapidly

124

F150 (TF6)

Universal Garage Door Opener

(If Equipped)

Advertising
This manual is related to the following products: