Np30, Limited warranty, Plug fitting instructions (uk only) – Cambridge Audio SONATA NP30 User Manual

Page 5: Europe-european union notice

Advertising
background image

5

NP30

ENGLISH

Cambridge Audio warrants this product to be free from defects in materials

and workmanship (subject to the terms set forth below). Cambridge Audio will

repair or replace (at Cambridge Audio’s option) this product or any defective

parts in this product. Warranty periods may vary from country to country. If in

doubt consult your dealer and ensure that you retain proof of purchase.
To obtain warranty service, please contact the Cambridge Audio authorised

dealer from which you purchased this product. If your dealer is not equipped

to perform the repair of your Cambridge Audio product, it can be returned by

your dealer to Cambridge Audio or an authorised Cambridge Audio service

agent. You will need to ship this product in either its original packaging or

packaging affording an equal degree of protection.
Proof of purchase in the form of a bill of sale or receipted invoice, which is

evidence that this product is within the warranty period, must be presented to

obtain warranty service.
This Warranty is invalid if (a) the factory-applied serial number has been altered

or removed from this product or (b) this product was not purchased from a

Cambridge Audio authorised dealer. You may call Cambridge Audio or your

local country Cambridge Audio distributor to confirm that you have an

unaltered serial number and/or you made a purchase from a Cambridge Audio

authorised dealer.
This Warranty does not cover cosmetic damage or damage due to acts of God,

accident, misuse, abuse, negligence, commercial use, or modification of, or to

any part of, the product. This Warranty does not cover damage due to improper

operation, maintenance or installation, or attempted repair by anyone other

than Cambridge Audio or a Cambridge Audio dealer, or authorised service

agent which is authorised to do Cambridge Audio warranty work. Any

unauthorised repairs will void this Warranty. This Warranty does not cover

products sold AS IS or WITH ALL FAULTS.
REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS WARRANTY ARE THE

EXCLUSIVE REMEDY OF THE CONSUMER. CAMBRIDGE AUDIO SHALL NOT BE

LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF

ANY EXPRESS OR IMPLIED WARRANTY IN THIS PRODUCT. EXCEPT TO THE

EXTENT PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF

ALL OTHER EXPRESS AND IMPLIED WARRANTIES WHATSOEVER INCLUDING,

BUT NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY AND FITNESS

FOR A PRACTICAL PURPOSE.
Some countries and US states do not allow the exclusion or limitation of

incidental or consequential damages or implied warranties so the above

exclusions may not apply to you. This Warranty gives you specific legal rights,

and you may have other statutory rights, which vary from state to state or

country to country.
For any service, in or out of warranty, please contact your dealer.

Limited warranty

Plug Fitting Instructions (UK only)

The cord supplied with this appliance is factory fitted with a UK mains plug

fitted with a 3 amp fuse inside. If it is necessary to change the fuse, it is

important that a 3 amp one is used. If the plug needs to be changed because

it is not suitable for your socket, or becomes damaged, it should be cut off

and an appropriate plug fitted following the wiring instructions below. The plug

must then be disposed of safely, as insertion into a mains socket is likely to

cause an electrical hazard. Should it be necessary to fit a 3-pin BS mains plug

to the power cord the wires should be fitted as shown in this diagram. The

colours of the wires in the mains lead of this appliance may not correspond

with the coloured markings identifying the terminals in your plug. Connect

them as follows:
The wire which is coloured BLUE must be

connected to the terminal which is marked with

the letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be

connected to the terminal which is marked with

the letter 'L' or coloured RED.
The wire which is coloured GREEN/YELLOW

must be connected to the terminal which is

marked with the letter 'E' or coloured GREEN.
If a standard 13 amp (BS 1363) plug is used, a 5 amp fuse must be fitted, or

if any other type of plug is used a 5 amp fuse must be fitted, either in the plug

or adaptor, or on the distribution board.

IMPORTANT NOTE:

IC Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for

uncontrolled environments. This equipment should be installed and operated

with a minimum distance of 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.
Cet appareil numérique de la classe B conforme á la norme NMB-003 du

Canada.

Europe-European Union Notice

Radio products with the CE 0889 or CE alert marking comply with the R&TTE

Directive (1995/5/EC) issued by the Commission of the European Community.
Compliance with this directive implies conformity to the following European

Norms.
• EN 60950-1 – Product Safety.
• EN 300 328 – Technical requirement for radio equipment.
• EN 301 489 – General EMC requirements for radio equipment.
To determine the type of transmitter, check the identification label on your

Cambridge Audio product.
Products with the CE marking comply with European Low Voltage

(2006/95/EC), Electromagnetic Compatibility (2004/108/EC) and

Environmentally-friendly design of Energy-related Products (2009/125/EC)

Directives issued by the Commission of the European Community. Compliance

with these directives implies conformity to the following European Norms.
• EN 55022 – Electromagnetic Interference.
• EN 55024 – Electromagnetic Immunity.
• EN 61000-3-2 – Power Line Harmonics.
• EN 61000-3-3 – Power Line Flicker.
• EN 60950-1 – Product Safety Products that contain the radio transmitter are

labeled with CE 0889 or CE alert marking and may also carry the CE logo.

• EN 62301:2005 - Household electrical appliances. Measurement of standby

power.

• 1275/2008 - Implementing EuP Directive for Standby Power Consumption.

Advertising