Bissell 1456E - Manual (Page 13)

Maintenance & Care
brush removal and brush belt
replacement
The brushes and brush belt can be removed
for cleaning or replacement as needed.
1. Turn off machine and unplug it from outlet.
2. Remove 2-in-1 water tank and set aside.
3. Remove nozzle by turning locking keys
counterclockwise to “unlock” position and
lifting nozzle up and away.
4. Turn machine on its side. Important: make
sure corded side is facing up.
5. Remove 1 silver screw from pivot arm.
6. Remove pivot arm by gently lifting up
and set aside.
7. Remove drive belt. if worn or damaged,
replace with new drive belt.
8. Remove brush rolls by pulling them off metal
rods. be careful not to lose small washer at each
end of brush rolls.
9. Remove brush belt from the end of brush
and set aside. if worn or damaged, replace
with new brush belt.
10. Place cleaned or new brush rolls back onto
metal rods. Make sure one washer is on each
of brush rolls prior to sliding onto metal rods.
be sure metal rods slide through bushings to
ensure proper fit.
11. Re-attach brush belt on bottom of cogs of
small roller brushes.
12. Re-attach drive belt by first attaching it
to small drive wheel, then attach it to end of
inside brush.
13. Place pivot arm back on and secure in place
using silver screw.
14. Replace nozzle by lining up locking keys with
their slots and placing nozzle back onto foot of
machine. secure into place by turning locking
keys clockwise to “lock” position.
if you have any questions or are having trouble
installing or replacing your belt(s) or brushes,
please call bissell Consumer Care.
www.bissell.com
13
1
4
6
8
10
12
14
2.
3.
9.
4.
6.
10.
5.
11.
13.
12.
14.
7. 8.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.