Bissell 37Y8E - Manual (Page 7)

w w w . b i s s e l l . c o m
7
O
perations
4. Pre-Treating (optional) Pre-treat stub-
born stains and highly soiled carpet in
hallways and other high-traffic areas.
4a. Generously spray BISSELL Tough Stain
Precleaner evenly over soiled area.
Caution: DO NOT OVER WET CARPET
4b. Wait 3-5 minutes before deep cleaning.
Fill the tank
1. Remove the solution tank by lifting it straight
up, then away from the lower body.
2. Unscrew the black cap at the bottom of
the solution tank.
3. Fill with hand hot tap water to the WATER
line. Fill the rest of the tank with BISSELL
2X Formula to the FORMULA line. Replace
and tighten the black cap.
4. Place solution tank on lower body.
Carpet cleaning
1. Set ReadyTools dial to
"FLOOR CLEANING".
2. Plug into proper outlet.
3. Turn the power switch to the ON (I)
position (located on the back of unit)
4. With foot, press the red recline lever
(located on the back of unit).
5. Cleaning Strokes. While pressing the
spray trigger, make one slow forward wet
pass and another one back. Caution: Do
not overwet.
6. Release the spray trigger and make one
slow forward and backward pass over the
same area.
7. Repeat steps 4 and 5 until solution being
pulled up appears clean.
8. Empty the collection tank when dirty water
reaches the full line, or when the solution
tank is empty.
Empty the collection tank
1. Turn power switch OFF (O) and unplug
power cord from outlet.
2. Remove the collection tank from base of unit.
3. & 4.
2.
1.
1.
4. 3.
Recline
Lever
Power
Before you clean continued