Bissell 90D3E - Manual (Page 8)

w w w . b i s s e l l . c o m
M
aintenance and care
8
When your done
1. Turn power switch off.
2. Unplug power cord from outlet.
3. Remove and empty collection tank.
a. Release collection tank latches [1 each
side] by pulling up from bottom of latch
and then out.
b. Carefully remove collection tank from
lower body by lifting handle.
c. Carry collection tank to a toilet or sink.
To empty, pour out contents using open-
ing at back of tank.
d. Rinse collection tank thoroughly.
e. Remove vent cover from top of collec-
tion tank by pulling the tab on top and
pulling up. Remove foam filter from
vent cover. Rinse filter thoroughly and
replace back into vent cover. Replace
vent cover back into collection tank,
making sure the tab clicks back into the
locked position.
4. Remove lint and hair from red gasket in
base of unit. (do not remove gasket)
5. Clean nozzle window by lifting latch and
removing from machine. Rinse under run-
ning water. When finished replace nozzle
and secure with latch.
6. Replace collection tank on lower body
and secure with latches.
7. Wrap power cord around Quick Release
Cord Wrap ™ on side of deep cleaner.
8. Wipe all surfaces with a soft cloth. Store
cleaner upright in a protected, dry area.
note: you may have cleaning solu-
tion remaining in the clean water/
solution tank. you may store your
deep cleaner this way for the next
cleaning task, but never keep soiled
solution in the collection tank.
WARNING:
To reduce the risk of injury
from moving parts and/or
electrical shock, turn power
switch OFF and disconnect
plug from electrical outlet
before performing mainte-
nance or troubleshooting
checks.
caution:
Do not store unit where
freezing may occur.
Damage to internal com-
ponents may result.