Bissell 20W7E - Manual (Page 7)

w w w. b i s s e l l . c o m
7
3.
2.
4.
Power
Recline
2a.
3.
2b.
fill the tank (cont)
4. Place solution tank on lower body.
tip: to ensure proper function, make
sure the tank is completely seated.
failure to do so can result in reduced
or no spray.
carpet cleaning
1. Plug into proper outlet.
2. Adjust the retractable handle by turning
counterclockwise and lifting the handle
up. Turn clockwise to secure.
3. With foot press the red power lever,
located on the back of the machine.
note: Handle must be in the full
upright position before cleaning.
4. With foot, press the recline lever
located next to power lever.
5. Cleaning Strokes. While pressing the
spray trigger, make one slow forward
wet pass and another one back.
caution: do not overwet.
6. Release the spray trigger and make one
slow forward and backward pass over
the same area.
7. Repeat steps 5 and 6 until solution
being pulled up appears clean.
8. Empty the collection tank when dirty
water reaches the full line, or when
the solution tank is empty.
empty the collection tank
1. With foot, press the red power lever to turn
off and unplug power cord from outlet.
2. Remove the collection tank from base of unit.
2a.
Release collection tank latches
(on each side) by pulling up from the
bottom of latch and then out.
2b. Carefully remove tank by lifting
up on the tank handle.
3. Carry collection tank to a toilet or
sink. To empty, pour out contents
using opening at back of tank.
WaRning:
To reduce the risk of fire and
electric shock- when cleaning a
hard floor, the BISSELL hard floor
tool (203-5705) must be used
and it must only be used with
BISSELL 2X hard floor Solutions
cleaning fluid intended for use
with this appliance.
O
perations