Bissell 1623E - Manual (Page 13)

13
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of fire, electric
shock or injury, unplug from the
outlet before servicing. T
roubleshooting
Reduced Spray OR No Spray
Possible cause Remedies
1. Bladder may be empty 1. Turn power switch OFF; Refill bladder
with clean hand hot tap water.
2. 2-in-1 water tank may not be seated properly. 2. Turn power switch OFF; remove and
reseat tank.
3. Pump may have lost prime. 3. Turn power switch OFF; after 1 minute
turn ON and depress spray trigger.
4. The pump belt may be broken. 4. Turn power switch OFF and unplug from
the outlet. To check if a pump belt has broken,
you will need a flat head screwdriver.
A. Insert the blade end into the slot of the
belt access door to release. Examine the
belt for breakage. You should be able to see
the pump belt looped around the motor shaft.
If it is broken or missing, please refer to
Replacement Parts on page 15 before calling
BISSELL Consumers Services. Complete
installation instructions will accompany the
replacement belt.
B. When replacing belt access door be sure to
line up slots of belt access door with slots in
machine, slide door into place and snap shut.
DirtLifter PowerBrush Does Not Turn
Possible cause Remedies
1. The brush belt or pump belt is off or broken. 1. Refer to Remedy 4 above to check if brush
belt or pump belt is broken.
Cleaner Not Picking Up Solution
Possible cause Remedies
1. Removable nozzle may not be properly attached. 1. Make sure nozzle is on correctly by slightly
raising front of machine to line up slots on the
base of the machine with the hooks on nozzle.
Attach at base first and then click nozzle into place.
2. 2-in-1 water tank lid is not properly installed. 2. Re-install lid; refer to the image on page 7.
3. 2-in-1 water tank is not properly seated. 3. Tank must be firmly seated to function;
remove and reseat tank.
4. 2-in-1 water tank has picked up maximum dirty water. 4. Empty tank and refill, refer to the
Operation section.
5. The lint screen may be clogged 5. Clean out lint screen. Refer to page 8.
Slots
A.
B.
Pump Belt
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store
ug120-4039_1623E_508.indd 13 ug120-4039_1623E_508.indd 13 5/19/08 12:30:04 PM 5/19/08 12:30:04 PM