Bissell 3278 - Manual (Page 13)

Troubleshooting
problem possible causes Remedies
Reduced
spray oR
no spray
bladder may be empty.
Press power pedal
off; refill
bladder with clean hand hot
(60°F/140°C MAX) tap water and
formula.
2-in-1 tank may not be seated
properly.
Press power pedal
off; remove
tank and reseat tank.
Pump may have lost prime.
Press power pedal
off; after 1 min-
ute turn on and depress spray trigger.
Pump belt may be broken.
Press power pedal
off and unplug
from outlet. Follow belt replacement
instructions on pages 11 and 12.
Dirtlifter
powerbrush
does not turn
brush belt or pump belt is
off or broken.
Press power pedal
off and unplug
from outlet. Follow belt replacement
instructions on pages 11 and 12.
cleaner
not picking
up solution
ReadyTools dial may be on wrong
setting for cleaning job.
set ReadyTools dial to either floor
cleaning or tools.
Poor tool position. (Hand held
attachments only).
Adjust angle; apply more downward
pressure.
Removable nozzle may not be
properly attached.
Make sure nozzle is on correctly by
slightly raising front of machine to
line up slots on each side of base of
machine with hooks on each side of
nozzle. Attach at base first and then
click nozzle into place. Refer to image
6 on page 8.
2-in-1 tank lid is not properly installed. Re-install lid; refer to images on page 7.
2-in-1 tank is not properly seated. 2-in-1 tank must be firmly seated to
function; remove and reseat 2-in-1 tank.
2-in-1 tank has picked up
maximum dirty water.
empty 2-in-1 tank and refill, refer to
the Operation section.
The lint screen may be clogged. Clean out lint screen, refer to page 8.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a bissell product.
please do
not return
this product
to the store.
www.bissell.com
13
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.