Bissell 9500E - Manual (Page 10)

10 w w w . b i s s e l l . c o m
O
peration
Carpet cleaning
1. Fill the 2-in-1 Water Tank. Remove the tank
from the base of the machine by lifting up the
tank carry handle. Carry like a bucket to the sink.
1a. Unlatch the top of the tank from the bottom
by lifting up on the tank latch which is located
on the back of the tank.
1b. Remove the top of the tank by lifting up on
the handle.
Note: Be sure to note how the lip on the
top tank separates from the groove in the
bottom tank. This placement is important
when putting the tank back together
1c. Fill the heavy duty bladder with clean hand
hot tap water.
*Do not boil or microwave water as it can
destroy the bladder.
1d. Leaving the filled bottom of the tank on a
flat surface, only maneuver the top of the
tank. To attach the top part of the tank to the
bottom, carefully hook the lip on the top tank
into the groove on the bottom tank.
1e. Fasten tanks together by securing the latch
in the back.
Note: Remember to secure the tank latch in
the back and test to make sure it is secure
before picking up the tank.
2. Remove formula tank from back of machine.
2a. Fill the formula tank by first unscrewing the
cap and insert. Always use genuine BISSELL
formulas to maximize cleaning and for the
safety of your machine. Fill formula up to the
line and replace the cap and insert. Place
formula tank into the slot in the back of the
machine for a snug fit.
3. Set Custom Clean Dial. Simply choose one
of the 4 settings (heavy traffic, normal clean,
light clean or water rinse) and the ProHeat
2X will adjust the right amount of cleaning
formula to mix with the heated water to fit
your cleaning need.
4. Set ReadyTools Dial to the floor cleaning setting.
1. 1a.
1b.
FLOOR
CLEANING
2. 2a.
4. 3.
Lip
Groove
(underside of
bottom tank)
1c.
1d.
1e.
ug120-4042_9500E.indd 10 ug120-4042_9500E.indd 10 5/7/08 3:37:44 PM 5/7/08 3:37:44 PM