Bissell 26Y1 - Manual (Page 11)

w w w . b i s s e l l . c o m
11
M
aintenance and care
The post-motor HEPA media filter
assists in the filtration process to
return clean air to the room. Use only
BISSELL replacement filters in your
CleanView Multi Cyclonic.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. The post-motor filter is located behind
the door labeled “FILTER” on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3. Remove the post-motor HEPA media
filter by grasping the handle on the filter
and pulling out to remove.
4. Replace the post-motor HEPA media
filter with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter. This
filter is NOT washable and must be
replaced when it becomes dirty.
5. Replace the filter door by inserting the
two tabs at the bottom of the filter door.
Then push down on the tab on the
door and push it back into the vacuum.
Release the tab on the door to lock into
place.
Cleaning the Post-motor HEPA media filter
Post-Motor HEPA
Media Filter
2.
3.