Bissell 1427 - Manual (Page 7)

7
clearing clogs from the dirt cup
1. Unplug the vacuum from electrical outlet.
2. Remove the dirt cup from the vacuum,
following steps 1-3 of emptying the dirt cup
on page 6.
3. Remove the dirt cup filter assembly from
the dirt cup, following step 2 of Clean the
dirt cup filter on page 6.
4. Tap the dirt cup filter assembly over a
garbage container to remove any dirt or
debris from the cyclone screen that sur-
rounds the dirt cup filter.
5. Reach up into the dirt cup to clear any dirt
or debris from the dirt cup.
6. Check to see if there are any clogs
in the suction inlet.
7. After clearing any dirt or debris from
the dirt cup, replace the dirt cup filter
assembly back in the dirt cup following step
8 of Cleaning the dirt cup filter on page 6.
maintaining the pet
turbobrush
™
tool
The Pet Turbobrush™ Tool should be
checked regularly for clogs or debris wrap-
ping around the brush.
1. Unplug the vacuum from the outlet.
2. if the clog is present or debris is vis-
ible, turn the collar on the neck of the Pet
Turbobrush™ Tool counterclockwise to the
unlocked position to remove the faceplate
and clear any obstructions.
3. To clean debris from the brush, remove
the brush from the drive belt and clean
debris.
4. Reposition the drive belt on the brush.
Place the ends of the brush in the slots on
the sides. Reposition the faceplate and turn
the collar clockwise to the locked position.
Replacement Parts
These items are available for purchase as accessories for your BISSELL vacuum:
To purchase visit www.BISSELL.com.
pArT # pArT nAme pArT # pArT nAme
203-1771 Dirt Cup Filter Screen 203-1772 Dirt Cup Filter
203-1786 Post-Motor Filter 160-3821 Floor Nozzle
203-1537 Hose with Handle 203-1538 Extension Wands (2)
203-1539 Combination Crevice Tool/
Dusting Brush 160-3063 Pet TurboBrush™ Tool