Maintenance & care, Warning, Brush roll maintenance – Bissell 1189E User Manual

Page 9

Advertising
background image

Maintenance & Care

brush Roll maintenance

The brush roll may accumulate debris such as

strings, hair and fibers. This type of debris can

wrap around the brush and diminish its ability

to clean effectively.
The lift-Off 2-in-1 Cyclonic features two

specialized brush rolls which can be easily

changed to optimize cleaning on different

floor types. Use the multi-surface brush roll

for general cleaning on hard floor and area

rugs, or switch to the hardfloor brush roll for

improved cleaning on hard floor surfaces.

to remove the brush roll

1. Turn power OFF (O). Remove foot assembly

from unit and turn over to access the brush roll.
2. Use a coin to unlock the yellow locking tab

and lift up to free the brush.
3. To remove the brush roll, simply lift the brush

out of the brush chamber.
4. Clean as needed and replace, or switch the

brush as desired.
5. Place the clean brush roll back into the brush

chamber by aligning the non-belt side so it’s

seated within the nozzle, then pivot the belt side

down into position.
6. Replace the locking tab and use a coin to

lock in place. Attach the foot assembly back

to the unit.

brush roll reset:

if larger debris becomes lodged in the foot of

the unit and the brush roll shuts off, turn the unit

off and remove the obstruction. Wait approxi-

mately 15 seconds for the motor to cool down

before turning back on. brush will function again

after allowing time to cool down.

www.bissell.com

0844.888.6644

9

1.

2.

3.

4.

WaRnInG

To reduce the risk of electric shock, turn power switch off

and disconnect polarized plug from electrical outlet before

performing maintenance or troubleshooting checks.

Advertising