Dick SM-140 UltraSharp 230V User Manual
Page 31
Belt grinder SM-140
31
Servicing and maintenance
9
1 Remove the water tank (see "Cleaning the belt grinder"
2 Undo the fastening screws [1] of the right-hand side
panel [2],
3 Remove the side panel [2],
4 Undo the belt tensioner [6] with clamping lever [7] and turn
anti-clockwise to relax (see "Adjusting the belt alignment
and running" on page 18),
5 Pull the deflection pulley [4] inwards and remove the grin-
ding belt [3],
6 Put on the new grinding belt so that the direction of rotation
indicated on the grinding belt [5] matches the direction of
rotation of the belt grinder,
7 Install the individual parts in the reverse order.
8 Check the belt running and if necessary adjust
(see "Setting & adjusting the belt grinder" on page 17).
Figure 9.2 – Grinding arm
[3] Grinding belt
[4] Deflection pulley
[5] Direction of rotation indication on the grinding belt
[6] Belt tensioner
[7] Tensioning lever
3
4
5
6
7