Dogtra 1500 Series - Manual (Page 13)

22
CHARGING THE BATTERIES
23
TESTING
1. Turn the collar on by pressing the button
on the back side of the collar receiver.
The indicator light will come on for a
moment then blink once every two
seconds, showing that the collar is ready
to use. (If the indicator light is red, the
batteries need to be charged.) Place the
test light on the contact points of receiver
and hold it there.
TESTING YOUR
COLLAR
Battery Charging Procedure
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on
page 20.
2. Plug the charger into a 120-volt wall outlet
or, if using the accessory field charger,
plug into a cigarette lighter. (Use a 230-
volt European charger for Europe.) When
properly plugged in, all indicator lights
should glow red.
The receiver automatically turns off when
you insert the charging cable into the
battery-charging receptacle on the receiver.
3. After charging, cover the battery charging
receptacles with the rubber plugs on the
transmitter and receiver.
4. The battery is fully charged with a 14-hour
charge. The lights will stay red during the
charging process. They DO NOT turn
green when fully charged. Charging the
batteries for more than 14 hours at one time
will not extend battery life.