Dogtra 200 Series - Manual (Page 13)

23
TESTING
Battery Charging Procedure
1. Attach the charging cables to both the
transmitter and receiver(s), as shown on
page 20.
2. Plug the charger into a 120-volt wall outlet
or, if using the accessory field charger,
plug into a cigarette lighter. (Use a 230-
volt European charger for Europe.) When
properly plugged in, all indicator lights
should glow red.
The receiver automatically turns off when
you insert the charging cable into the
battery-charging receptacle on the receiver.
3. After charging, cover the battery charging
receptacles with the rubber plugs on the
transmitter and receiver.
4. The battery is fully charged with a 14-hour
charge. The lights will stay red during the
charging process. They DO NOT turn
green when fully charged. Charging the
batteries for more than 14 hours at one time
will not extend battery life.
22
CHARGING THE BATTERIES
1. To activate the , place
the red dot on the back of the transmitter to the
red dot on the collar receiver. Hold the two red
dots together for a moment until the LED
indicator light comes on. The indicator light
will blink every two seconds showing the unit
is charged and ready to use. (If the indicator
light emits a red color, the batteries need to be
charged.)
TESTING YOUR
COLLAR