EcoPure ECOP20 User Manual

Page 3

Advertising
background image

3

Questions? Call toll free: 1-800-693-1138

Parts of the System

Materials and Tools Needed

Typical Undersink Installation

• filter system assembly
• water supply fitting
• filtered water faucet for sink or countertop mounting
• 3/8" tube bends
• 3/8" tubing to make all needed connections

NOTE: Gather the required tools before starting installation. Read and follow

the instructions provided with any tools listed here.
• slotted and Phillips screwdrivers
• pliers and adjustable jaw wrench
• tubing cutter
• electric drill and 1-1/4" drill bit if mounting hole is needed for the faucet
IMPORTANT: To avoid damaging the sink, consult a qualified plumber or

installer for drilling procedures in porcelain or stainless steel.

Locate the water filter housing on the cold water supply pipe, under the kitchen and/or bathroom sink, to

filter the cold drinking water. Refer to the following drawing.

shutoff valve

filtered water

faucet

filter 2

filter 1

Blue

WATER

OUT

Yellow

WATER

IN

supply fitting

SINK

NOTE: If tubing needs to make a sharp

bend, use included tube benders to

prevent kinking.

NOTE: Be sure to allow a minimum space of 1-1/2" under the system

for removing the filter cartridges, in order to change the cartridges.

Fig. 1

4-1/4”

HOT

COLD

Advertising