BMW 135i Convertible 2011 User Manual
Page 135
133
Xenon lamps*
These bulbs have a very long service life and are
highly unlikely to fail. If a xenon lamp fails never-
theless, switch on the fog lamps and continue
the journey with great care, provided that local
legislation does not prohibit this.
Have any work on the xenon lamp system,
including bulb replacements, performed
only by a BMW center or a workshop that works
according to BMW repair procedures with cor-
respondingly trained personnel. Otherwise, if
such work is carried out improperly, the high
voltage in the system presents the danger of
fatal injuries.
<
Removing the headlamp cover
1.
Pull the wire brackets over the notches, see
arrows, and fold to the side.
2.
Fold away the headlamp cover.
Be careful when attaching the headlamp
cover and ensure that both wire brackets
are securely in place; otherwise, leaks could
occur and cause damage to the headlamp sys-
tem.
<
Attach the headlamp cover in reverse order.
Halogen headlamps
Halogen low beams and high beams
H7 bulb, 55 watts
Always wear gloves and eye protection;
the atmosphere within the H7 bulb is
pressurized. Otherwise, there is a risk of injury if
the bulb is damaged.
<
The figure shows the right-hand headlamp.
1 High beams
2 Low-beam headlamps
1.
Remove the headlamp cover.
2.
Fold down the holding bracket.
3.
Remove and replace the bulb.
4.
Reattach the bulb holder with the notch at
the top.
5.
Fold the holding bracket back up and let it
snap into place.
6.
Attach the headlamp cover.
Parking lamps, roadside parking lamps
W5W bulb, 5 watts
1.
Remove the headlamp cover.
The figure shows the right-hand headlamp.
2.
Pull out the bulb holder.
3.
Remove and replace the bulb.
4.
Reinsert the bulb holder.
5.
Attach the headlamp cover.
Online Edition for Part no. 01 41 2 604 079 - © 02/10 BMW AG