BMW X6 xDrive50i 2011 User Manual

Page 91

Advertising
background image

Co

n

tr

o

ls

89

Refere

nce

At a glan

ce

Dr

ivi

n

g ti

ps

Co

mm

un

icat

io

ns

Navigation

Ente

rt

ai

nme

n

t

M

o

bi

lity

>

After approx. 165 ft/50 m when driving for-
ward

>

At speeds over approx. 25 mph/35 km/h
when driving forward

Switch the system back on as needed.

Switching on/off manually

Press the button.

>

On: LED lights up

>

Off: LED goes out

Signal tones

When nearing an object, the position is corre-
spondingly indicated by an interval tone. Thus,
an object detected to the left rear of the vehicle
will be indicated by a signal tone from the left
rear speaker, etc.
The shorter the distance to the object
becomes, the shorter the intervals become.
If the distance to the nearest object falls to
below roughly 1 ft/30 cm, then a continuous
tone sounds.
If objects are present both in front of and behind
the vehicle, then an alternating, continuous
tone sounds.
An intermittent tone is interrupted after approx.
3 seconds:

>

When the vehicle remains stationary in front
of an object that has only been detected by
one of the corner sensors

>

When driving parallel to a wall

The signal tone is switched off:

>

When the vehicle is more than approx.
4.0 in/10 cm away from an object

>

When the selector lever is in the P position

Volume

You can adjust the volume of the signal tone,
refer to page

87

.

The setting is stored for the remote control cur-
rently in use.

Optical warning

The approach to an object can be shown on the
Control Display. Objects that are farther away
are displayed on the Control Display before a
signal tone sounds.

The display appears as soon as PDC is acti-
vated.
If the last image selected was the rear view
camera, this is displayed again. To switch to
PDC:

1.

Select the

"Switch off rear view cam-

era" on the Control Display.

2.

Press the controller.

The setting is stored for the remote control cur-
rently in use.

Image on the Control Display

Switching on the rear view camera

using iDrive

With PDC activated:

1.

Select the

"Rear view camera" symbol.

2.

Press the controller.

The image of the rear view camera is displayed.
The setting is stored for the remote control cur-
rently in use.

Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG

Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG

Advertising